LIVE CELL TRANSPORTATION

ABOUT LIVE CELL TRANSPORTATION
Phase Change Material

Highly accurate temperature maintenance capability. Can be used repeatedly!

Phase change material

Keeps temperature stable for a long period of time.
High-performance heat and cold storage materials in tray form that can be used repeatedly.

Adaptable to various transportation conditions

Lineup of 4 temperature zones: 36°C, 24°C, 17°C, and 5°C
The lineup includes 4 temperature zones: 36°C zone for the same conditions as incubators, 24°C zone for the same conditions as CPC and medical settings, 17°C zone for both cold and warm storage, and 5°C zone for long-term cold storage without freezing. These zones meet a wide variety of transportation conditions.

Can be stacked stably

Tray-shaped design for laboratory use
The heat/cold storage materials have tray-shaped sides, ensuring stable stacking. Their size permits placement of two plates side by side, suitable for both constant-temperature transportation and serving as thermal trays in laboratories, etc.
*The temperature maintenance time will be shorter when used without being placed in a transport box.

LINE UP

OTHER PRODUCTS

LINE UP

iP-TEC®

Phase Change Material +36

iP-TEC®

Phase Change Material +24

OTHER PRODUCTS

Thermal storage material

temperature controller ACT3

Compact infrared radiation

thermometer

iP-TEC®

Phase Change Material +5

iP-TEC®

Phase Change Material +17

Specialized rack

for heat storage materials

OTHER PRODUCTS

Thermal storage material

temperature controller ACT3

Compact infrared radiation

thermometer

Specialized rack

for heat storage materials

Easy temperature control of heat storage material with just 3 buttons!
Phase Change Material temperature controller ACT3

Optimal temperature control of heat storage materials in 3 temperature zones can be achieved with just 3 buttons!

Labor-saving temperature control
with this one unit

Built-in temperature control programs of 36°C, 24°C, and 5°C
The temperature controller is pre-programmed for optimal temperature control of the 3 temperature zones of the iP-TEC® latent heat/cold storage materials. Simply select the program for the desired temperature range to start automatic temperature control. This single unit saves labor for temperature control. Manual operation is also available.

More than enough storage capacity

Temperature control of up to 27 pieces at a time
By using the specialized rack (sold separately), a total of 27 heat/cold storage materials can be stored, 12 each on the upper and lower racks and 3 flat on the bottom. The temperature controller has sufficient storage capacity not only for use immediately after temperature-control, but also for stocking already temperature-controlled materials.

LINE UP

OTHER PRODUCTS

Heat storage material temperature controller ACT3

OTHER PRODUCTS

iP-TEC®

Phase Change Material +36

iP-TEC®

Phase Change Material +24

iP-TEC®

Phase Change Material +5

Specialized rack

for heat storage materials

Simple temperature control set exclusively for heat storage material+36
Phase Change Material temperature control box set

Premier BOX-V19 in combination with a heater unit can control the temperature of heat storage material at 36°C

Labor-saving temperature control
with this one unit

Combination of tertiary container and heater unit enables temperature control of Phase change materials
By installing a heater unit in iP-TEC® Premier BOX-V19, Phase change materials in the 36°C zone can be heated. By using the included specialized rack, a maximum of 6 Phase change materials can be heated.

LINE UP

OTHER PRODUCTS

Phase change material temperature control box set

OTHER PRODUCTS

iP-TEC®

Phase Change Material +36

The solution to these is iP-TEC®’s Live Cell Transport Products
Primary containers
Secondary containers
Tertiary containers
Phase change material